Mortein Indoor & Outdoor Lavender Prime 154g

Choosing the Best Setting: Mortein Multi Insect Automatic Spray Indoor & Outdoor Control System gives you the control you need to enjoy protection from pests every day. Choose the time setting that meets you needs according to the table below. Indoors Insect: Mosquitoes, Flies, Moths Windows/Doors: Open; Recommended Setting #: Hi Windows/Doors: Closed; Recommended Setting #: Lo Insect: Cockroaches, Fleas Windows/Doors: Open, Closed; Recommended Setting #: Hi Insect: Ants Windows/Doors: Open, Closed; Recommended Setting #: Lo Outdoors Insect: Flies, Most prevalent Area Conditions: Large area/windy Recommended Setting #: Hi Insect: Mosquitoes, most prevalent Area Conditions: Small area / calm Recommended Setting #:Insect: Lo 3 Hour Automatic Cut-off on Outdoor Settings #The choice of setting may be affected by air changes, location layout, temperature, humidity & the time of day. The Hi Indoor setting releases product every 13 minutes, the Lo Indoor setting every 17 minutes. The Hi Outdoor setting releases product every 20 seconds, the Lo Outdoor setting every 40 seconds. CHOOSING WHERE TO LOCATE THE DIFFUSER[' Recommended rooms indoors include lounge & family rooms, away from immediate food preparation, children activity & pet sleeping areas. See 'wall mounting guide' for more information. In an outdoor setting, the device is only to be used in well ventilated, sheltered outdoor areas only when mosquitoes and flies are prevalent. Mount the diffuser at least 2m above the floor and not closer than 30cm from the ceiling, roof or any outdoor or indoor structure facing an open area (refer to 'wall mounting guide'). If it fails to spray, please read the TROUBLE-SHOOTING directions • NOT TO BE USED FOR ANY PURPOSE, OR IN ANY MANNER, CONTRARY TO THIS LABEL UNLESS AUTHORISED.

Setup Instructions: Setting Up Your Diffuser 1. To open the diffuser device, hold the base in one hand and the top in the other hand and twist anticlockwise. 2. Remove the battery pack provided from the base. 3. Remove the lid from the top half of the device and insert the 2 x AA batteries. Ensure the Positive (+) and Negative (-) terminals are aligned and replace the lid. 4. Ensure the diffuser is switched to the OFF position, (light will flash red once when device is switched to OFF mode is selected). Insert the refill into the base, align the small line marking (top edge of the device base) with the back of the can's spray nozzle. Place the top half of the device on the base ensuring the spray nozzle is facing through opening in the top half. Twist the top half clockwise lining up the triangle marking with the mark on the base. 5. Select the desired level of protection (see "Choosing the best setting" above). The flashing green light indicates the device will spray after a delay of 15 seconds. If there is no spray after 15 seconds, switch off the device and check steps 3 and 4 have been performed correctly before repeating step 5. 6. When the aerosol refill is almost empty, the red light will flash and the device will soon stop spraying. Turn the device off. Remove the refill and replace with a new refill using the above steps. Remove the lid and adjust device to desired setting and press the reset button. IMPORTANT: PLEASE retain this label for future reference when refilling.