FOR BEST RESULTS BEFORE YOU BEGIN:
Please read all of the directions and warning on the pack carefully before use.
• Perform a patch test on a small part of the area you wish to wax
• If skin appears normal after 24 hours, proceed with the full treatment
• The skin to be treated must be clean and dry. Avoid using moisturisers the day before you use the wax strips
• Hair to be removed should be at least 2mm long and no longer than 1cm. Trim the hair before waxing if necessary
• It is important to practice the technique on less sensitive areas like the arms and legs before using on the face and sensitive areas
Step1: Starting at the corners, slowly separate the strips, taking care that the wax contents are spread out uniformly. You now have 2 strips ready to use. Use one at a time.
Step 2: Apply to the area to be waxed, smoothing down over the hair in the direction of the hair growth. Pres down hard on the strip to ensure that the wax is gripping all the hairs.
Step 3: Immediately hold skin taut, and quickly zip the strip back against the direction of hair growth. By removing the strip immediately after application, any temporary irritation or redness will be minimised. When removing the strip, make sure to keep it close to the skin. Do NOT pull the strip in an upward motion.
USAGE ADVICE
TIPS FOR WAXING:
1. Nair was strips are reusable, so repeat steps 2 and 3 until the strips stop gripping.
2. If any wax is left on the skin, use the enclosed aftercare wipes. Alternatively, use baby oil and gently massage until the wax lifts off.
3. Water and soap will not remove the wax residue.
STORAGE AND DISPOSAL
Store below 30C
STORAGE INSTRUCTIONS
Store below 30 degrees C
Storage Temperature: 30 degrees C
Recyclable Packaging?: Yes
Recycling Code: 22 PAP| 20 C PAP (PCB)| 21 PAP